Hermosa Water Spot Remover
What You’ll Need
- Hermosa Water Spot Remover.
- Microfiber applicator pad for applying the product.
- Microfiber cloth for wiping.
- Gloves (latex or similar waterproof gloves are recommended).
- Bucket of clean water for rinsing.
Step-by-Step Instructions
Prepare the Vehicle
Start by washing the vehicle or cleaning the surface to remove any loose dirt or contaminants.
Work out of direct sunlight to prevent the product from drying too quickly.
Ensure the surface is cool to the touch.
Put on your gloves and let’s get started!
Apply the Product
Moisten a microfiber applicator pad with Hermosa Water Spot Remover.
Work on a small area at a time, approximately 50cm x 50cm.
Apply the product to the surface using a cross-hatch pattern to ensure even coverage.
Dwell Time
Allow the product to dwell on the surface for up to 30 seconds.
For stubborn, baked-on water spots, work the product into the surface during this time.
Clean and Neutralise
Re-clean the treated area with a damp micro-fibre cloth to neutralise the reaction and remove any excess product.
Repeat the process for older or more stubborn water spots, allowing a 30-second dwell time for each application.
Final Touch
After removing the water spots, you may need to reapply Hermosa Graphene Ceramic Coating if the surface was previously coated. This will depend on how much agitation was required and whether the original coating has been compromised.
For best results, recoat the entire panel to ensure a consistent, uniform finish.
Pro Tips
- Always test the product on a small, inconspicuous area before full application.
- Work on one section at a time for better control and effectiveness.
- Avoid letting the product dry on the surface.
- Store the product in a cool, dry place away from direct sunlight.
